Establishing call

To program DPH doorphone it is necessarily to establish call between PBX phone and doorphone.
Doorphone is programmed using DTMF tones send by phone connected to doorphone.

Programing mode entering: 0987

To enter programing mode - during established call dial: 0987
In programing mode:
- doorphone buttons don't operate and after pressing any button reject signal (low frequency) is generated.
- Loudspeaker is muted.

After pressing *, in every moment, entered parameter is canceled and program returns to XY coordinates selection.

After pressing # entered parameter is confirmed.
After pressing # doorphone answers as follows:
- confirmation signal (high frequency)
- rejest signal (low frequency) if entered parameter is improper.

Warning! Entering program mode is possible if jumper SETUP is ON.

DPH programming table is as follow

Y\X	0	1	2	3	4	Meaning
1	Short number 0 Top button [21]	Short number 1 Bottom button [empty]				Number dialed after pressing button. Max 16 digits No number - button disabled
2	Number dialing finish with #(Hash) [1] 1 - ON 0 - OFF	Only handset lifting [ ] Line occupation. In PBX hot line must be declared. 0-Top button 1-Bottom button Empty - hot line is inactive	Max call time [180] 10..360 sec	Not operated	DPH factory settings # confirm, after confirmation DPH resets	Settings
3	EZ opening time [3] 1..60 sec	EZ working mode [0] 0 - electrolock (NO) 1 - electromagnetic keeper (NC)	STA opening time [2] 1..60 sec	*Receiving DTMF [3]** 0 - no action 1 - EZ opening 2 - STA opening 3 - EZ and STA opening at the same time	User RFID action [3] 0 - no action 1 - EZ opening 2 - STA opening 3 - EZ and STA opening at the same time	Output settings EZ - electrolock, STA - automatic control
4	Speaker volume [3] Allowable values 0..7, 0 - minimal volume	Speaker volume change 2 - increase volume 8 - decrease volume During adjustment DPH speaker is active	Speaker sensitivity [1] 0 - small 1 - medium 2 - high			Acoustic settings
5	Service RFID card 0000 - store service card Service card enables to assign new RFID cards.	Remove RFID cards 0000- remove all RFID cards				RFID cards

XY coordinates acceptation causes high frquency (OK) signal generation.
It is possible to entering XY coordinates longer than 2 digits - only two last digits will be used.
XY coordinates confirmation - button HASH (#)
Parameter entering can be always canceled by STAR (*) button. as a result low audio signal (BAD) is generated and jump to coordinates selecting
Zaakceptowanie dowolnego parametru - klawisz HASH (#). Gdy wartość parametru jest prawidłowa i został on prawidłowo zapisany w FLASH - wygenerowany jest ton wysoki (OK) i skoczenie do wyboru współrzędnej XY.
Gdy wartość parametru jest błędna - wygenerowany jest sygnał niski (BAD) i skoczenie do wyboru współrzędnej XY.
Max czas rozmowy - nowa wartość obowiązuje od następnego połączenia