Difference between revisions of "DPH.IP Doorphone connection"
From pubWiki-en
| Line 17: | Line 17: | ||
|STA | |STA | ||
|- | |- | ||
| − | |AC ||rowspan="2"| power supply connections | + | |AC ||rowspan="2"| power supply connections 24 - 48VDC |
|- | |- | ||
|AC | |AC | ||
Latest revision as of 08:26, 13 October 2017
Connecting doorphone can be executed via appropriate cables connected to connecting terminal located on doorphone PCB. Connecting terminal is visible and accessible afer unscrewing front panel, this operation is described in chapter DPH - Opening doorphone casing.
|
Connections located in connection terminal, usetd to doorphone installation are presented in following table:
 |
earthing (for proper operation of doorphone over-voltage protection) |
| LAN | RJ45 socket for LAN cable (PoE support) |
| EZ | electrolock, 12V DC, max 0.7A |
| EZ | |
| STA | isolated normaly open relay connection used to control additional device - allowable voltage is equal to max 24V AC STA Max 0.7A |
| STA | |
| AC | power supply connections 24 - 48VDC |
| AC | |
| COD | opening door sensor - disconnection from GND decrease EZ relay operation time |
| POD | opening door button (relative to GND) |
| GND | ground for POD, COD signals |
Connection scheme of doorphone DPH.IP-KSxx.C is presented on following figure.
Connection scheme of doorphone DPH.IP-CR0RF is presented on following figures.
or 
