Leszekj at 06:57, 1 June 2020

2020-06-01T06:57:23Z

Grzegorzg at 09:03, 23 November 2011

2011-11-23T09:03:33Z

Grzegorzg: Created page with "Connecting doorphone can be executed via appropriate cables connected to connecting terminal located on doorphone PCB. Connecting terminal is visible and accessible afer unscrewi..."

2011-10-19T10:51:45Z

Created page with "Connecting doorphone can be executed via appropriate cables connected to connecting terminal located on doorphone PCB. Connecting terminal is visible and accessible afer unscrewi..."

New page

Connecting doorphone can be executed via appropriate cables connected to connecting terminal located on doorphone PCB. Connecting terminal is visible and accessible afer unscrewing front panel, this operation is described in chapter [[DPH - Opening doorphone casing|2.2 DPH - Opening doorphone casing]].
{{warning|Before connecting cables to connecting terminal, cables should be bring into the casing via hole located on casing backside.}}
Connections located in connection terminal, usetd to doorphone installation are presented in following table:
<center>
{|{{Prettytable}}
|-
|[[File:Ikona uziemiena biała.PNG]] || earthing (for proper operation of doorphone over-voltage protection)
|-
|LA ||rowspan="2"| PBX subscriber line (polarity is not important)
|-
|LA
|-
|EZ ||rowspan="2"| electrolock, 12V DC, max 0.7A
|-
|EZ
|-
|STA ||rowspan="2"| isolated normaly open relay connection used to control additional device - allowable voltage is equal to max 24V AC STA Max 0.7A
|-
|STA
|-
|AC ||rowspan="2"| power supply connections 14 - 35VAC or 12 - 25 VDC
|-
|AC
|-
|COD || opening door sensor - disconnection from GND decrease EZ relay operation time
|-
|POD || opening door button (relative to GND)
|-
|GND || ground for POD, COD signals
|}
</center>
Connection scheme of doorphone DPH is presented on following figure.<br>
<center>[[File:Schemat podlaczenia DPH.png]]</center><br>
DPH doorphone supply can be realized using AC or DC. Power supply device should be selected according user needs. Due to wide possibilities, Slican company doesn't offerany power supply device together with DPH doorphone, it remain to user decision. In Slican offer - as a separate position in price list - there is AC transformer TRS10-V18-N, with nominal voltage equal to 18V, this transformer fulfil supply requirements of DPH doorphone. Below is presented mentioned above transformer:
<center> [[File:Trafo TRS10-V18-N.png]]</center>

@@ Line 19: / Line 19: @@
 |STA
 |-
-|AC  ||rowspan="2"| power supply connections 14 - 35VDC or 12 - 25VAC
+|AC  ||rowspan="2"| power supply connections 14 - 35VDC or 18 - 25VAC
 |-
 |AC

DPH16 - Doorphone connection - Revision history

Leszekj at 06:57, 1 June 2020

Grzegorzg at 09:03, 23 November 2011

Grzegorzg: Created page with "Connecting doorphone can be executed via appropriate cables connected to connecting terminal located on doorphone PCB. Connecting terminal is visible and accessible afer unscrewi..."