Difference between revisions of "ITS - Connecting with PC"
From pubWiki-en
(→I haven't network with DHCP server - what is default PBX IP address?) |
(→I haven't network with DHCP server - what is default PBX IP address?) |
||
| Line 15: | Line 15: | ||
{{warning|To assign default IP address and switch off DHCP server, code '''*930''' should be dialed from tone phone connected to any FXS port}} | {{warning|To assign default IP address and switch off DHCP server, code '''*930''' should be dialed from tone phone connected to any FXS port}} | ||
*Selecting service *930 causes: | *Selecting service *930 causes: | ||
| − | ** switching off DHCP client (if it wasn't switched off earlier), it is confirmed by voice message "Service accepted", then after circa 3 seconds PBX resets automatically. After reset following network settings are stored in PBX: | + | **switching off DHCP client (if it wasn't switched off earlier), it is confirmed by voice message "Service accepted", then after circa 3 seconds PBX resets automatically. After reset following network settings are stored in PBX: |
IP - 192.168.0.247 | IP - 192.168.0.247 | ||
MASK - 255.255.255.0 | MASK - 255.255.255.0 | ||
GATEWAY- 192.168.0.1 | GATEWAY- 192.168.0.1 | ||
DNS - 194.204.159.1 | DNS - 194.204.159.1 | ||
| − | ** no settings change (if DHCP was switched off earlier), it is confirmed by voice message "Service active". | + | **no settings change (if DHCP was switched off earlier), it is confirmed by voice message "Service active". |
---- | ---- | ||
[[Slican_ITS| Back]] | [[Slican_ITS| Back]] | ||
[[Category:ITS]] | [[Category:ITS]] | ||
Revision as of 06:54, 11 August 2010
Connecting PC with PBX can be done using Internet browser. Congruent browser are listed below:
Congruent www browsers
- FireFox 3.5.x and 3.0.x - recommended by manufacturer
- Google Chrome 3.x
What IP address is assigned to Slican ITS by DHCP server? - *947
|
- Listened address should be entered to browser address bar and confirmed by Enter.
- Default access password: slican
Above mentioned setting (Slican ITS is DHCP client) is default.
I haven't network with DHCP server - what is default PBX IP address?
|
- Selecting service *930 causes:
- switching off DHCP client (if it wasn't switched off earlier), it is confirmed by voice message "Service accepted", then after circa 3 seconds PBX resets automatically. After reset following network settings are stored in PBX:
IP - 192.168.0.247 MASK - 255.255.255.0 GATEWAY- 192.168.0.1 DNS - 194.204.159.1
- no settings change (if DHCP was switched off earlier), it is confirmed by voice message "Service active".
