Difference between revisions of "DPH - Opening doorphone casing"
From pubWiki-en
| Line 1: | Line 1: | ||
| − | Front panel of DPH doorphone is fixed by wrench srews M4, included in | + | Front panel of DPH doorphone is fixed by wrench srews M4, included in purchased set. Location of these screws is marked by digit 1, visible on below figures. |
<center>[[File:DPH KS1RF przod oznaczenia.png]][[File:DPH KS2RF przod oznaczenia.png]]</center> | <center>[[File:DPH KS1RF przod oznaczenia.png]][[File:DPH KS2RF przod oznaczenia.png]]</center> | ||
Following table explains marking used on figures. | Following table explains marking used on figures. | ||
Revision as of 07:40, 19 October 2011
Front panel of DPH doorphone is fixed by wrench srews M4, included in purchased set. Location of these screws is marked by digit 1, visible on below figures.
Following table explains marking used on figures.
| Digit | Significance |
|---|---|
| 1 | Screws for fixing front panel |
| 2 | Doorphone speaker cover |
| 3 | Hole for microphone installed in doorphone |
| 4 | Address window |
| 5 | Establish call button |
| 6 | Mark, informing about RFID card reader |
|
To front panel the PCB board is fixed. It is visible after removing front panel. All elements neccessarily to doorphone installation are accessible and it is not needed to remove PCB from front panel. View of PCB fixed to front panel is presented on following figure:
_wnetrze.png)
