Difference between revisions of "DPH16 - Opening doorphone casing"

From pubWiki-en
Jump to: navigation, search
Line 1: Line 1:
 
Front panel of DPH doorphone is fixed by wrench srews M4, included in purchased set. Location of these screws is marked by digit 1, visible on below figure.
 
Front panel of DPH doorphone is fixed by wrench srews M4, included in purchased set. Location of these screws is marked by digit 1, visible on below figure.
<center>[[File:DPH KS16 przod oznaczenia.png]]</center>
+
<center>[[File:DPH KS16 przod oznaczenia.png|200px]]</center>
 
Following table explains marking used on figure.
 
Following table explains marking used on figure.
 
{|{{prettytable}}
 
{|{{prettytable}}
Line 20: Line 20:
 
{{warning|If in doorphones DPH.AB-KS16, you use card with standard credit card dimensions, it is enough to approach this card to 5 - 6cm from doorphone, in parallel to doorphone, bellow speaker so over PCB presented on below figure. If you use small pendants as RFID card, it is recommended to aproach such pendant to 1cm in place where there is mark described as 6 on above figure.}}
 
{{warning|If in doorphones DPH.AB-KS16, you use card with standard credit card dimensions, it is enough to approach this card to 5 - 6cm from doorphone, in parallel to doorphone, bellow speaker so over PCB presented on below figure. If you use small pendants as RFID card, it is recommended to aproach such pendant to 1cm in place where there is mark described as 6 on above figure.}}
 
To front panel the PCB board is fixed. It is visible after removing front panel. All elements neccessarily to doorphone installation are accessible and it is not needed to remove PCB from front panel. View of PCB fixed to front panel is presented on following figure:
 
To front panel the PCB board is fixed. It is visible after removing front panel. All elements neccessarily to doorphone installation are accessible and it is not needed to remove PCB from front panel. View of PCB fixed to front panel is presented on following figure:
<center>[[File:DPH KS1(2) wnetrze.png]]</center>
+
<center>[[File:DPH KS1(2) wnetrze.png|200px]]</center>

Revision as of 07:06, 15 March 2017

Front panel of DPH doorphone is fixed by wrench srews M4, included in purchased set. Location of these screws is marked by digit 1, visible on below figure.

DPH KS16 przod oznaczenia.png

Following table explains marking used on figure.

Digit Meaning
1 Screws for fixing front panel
2 Doorphone speaker cover
3 Hole for microphone installed in doorphone
4 LCD display
5 Doorphone keyboard
6 Mark, informing about RFID card reader
Warning! If in doorphones DPH.AB-KS16, you use card with standard credit card dimensions, it is enough to approach this card to 5 - 6cm from doorphone, in parallel to doorphone, bellow speaker so over PCB presented on below figure. If you use small pendants as RFID card, it is recommended to aproach such pendant to 1cm in place where there is mark described as 6 on above figure.

To front panel the PCB board is fixed. It is visible after removing front panel. All elements neccessarily to doorphone installation are accessible and it is not needed to remove PCB from front panel. View of PCB fixed to front panel is presented on following figure:

DPH KS1(2) wnetrze.png