MSB-1102 Instruction manual
From pubWiki-en
Contents
Information
Slican Multi Switch Box MSB-1102 it is device assuring cooperation between Slican PABX[1] and sensors, relays, alarm systems, paging systems etc.
Subscriber port in PABX should be configured as Sensor or Relay – depending on required function.
MSB-1102 Structure
MSB-1102 is equipped with following input/output ports:
- sockets AB1/AB2 type RJ11 for connecting 2 subscriber ports in PABX,
- socket 2REL[2] (REL1/REL2) type RJ45 which includes:
- sensor terminals (SNS1/SNS2) – configurable,
- monostable relay terminals[3] – configurable,
- socket ZAS – local power supply from external source.
Connecting and preparing for configuration
Configuration Jumpers
 |
|
Operating modes
| Power supply | Sensors (SNS) | Relays (REL) |
|---|---|---|
| Without power supply |  |
|
| With power supply |  |
|
According above table MSB-1102 must be supplied from local power supply device in following operating modes:
- Sensors: CCS mode
- Relays: VON/VOFF mode
Parameters
- prąd pobierany z zasilacza w trybie CCS maks. 20mA.
- pobór prądu w trybie DCI maks. 10mA na sensor.
- parametry styków przekaźnika (dla trybów NO/NC i VON/VOFF) - max 42Vac/0.5A, 42Vdc/1A
- zakres napięcia uaktywniającego sensor w trybach DCI i CCS to 5-30V[4]dc.
|
Certificate of conformity, proper device disposal
References
- ↑ MSB-1102 can be used with firmware version 4.10 or later. It can be used with Slican PABXes: CXS-0424, CCT-1668, MAC-Zero, MAC-6400.
- ↑ Device uses 2 independent channels. It means that simultaneously two functions can operate. Ex: 2 sensors, 2 relays or mix.
- ↑ Release pulse time is about 1 second.
- ↑ Uwaga: Istotna jest polaryzacja
