View source for DPH.IP Connecting devices of DPH.IP family

= Connecting two devices to EZ =
Building an ACS based on DPH.IP devices (KS1, KS4, KS16, CR0) should pay attention to connection of individual system components. <br>
When you connecting DPH.IP doorphone on one side and CR0RF card reader on other side to one EZ, connect appropriate contact inputs (according to diagram below) and program in PBX: <br>
* EZ-SEL jumper in DPH.IP set in NO mode
* connect '' 'EZ' '' output of TBRD.CR to '' 'EZ' ''
* connect '' 'POD' '' input of TBRD.CR with '' 'EZ' '' output of DPH.IP
<Center> [[File: DPHIP_CR0RF_1EZ_eng.png]] </center>
<br>
PBX configuration:
* IPx/CCT/MAC
** for DPH.IP doorphone in ConfigMAN Peripherals/Doorphones/DPH.IP/Hardware settings set option:
***''OpMD'' (Output mode '' 'EZ' ''): Switched off
** for CR0RF reader in ConfigMAN Peripherals/Doorphones/DPH.IP/Hardware settings set options:
*** ''POD'' (POD): Button
*** ''NmPOD'' (Normal POD state): Normally open

* NCP
** for DPH.IP doorphone in Extensions/Devices/DPH.IP/Doorphones/EZ output settings set option:
*** Enabled, Mode: Normally inactive
** for CR0RF reader in Extensions/Devices/DPH.IP/Doorphones/POD input settings set options:
*** Enabled, Resting state: Normally open
*** If POD button is pressed: Open EZ lock: V