DPH.IP Connecting devices of DPH.IP family

Connecting two devices to EZ

Building an ACS based on DPH.IP devices (KS1, KS4, KS16, CR0) should pay attention to connection of individual system components.
When you connecting DPH.IP doorphone on one side and CR0RF card reader on other side to one EZ, connect appropriate contact inputs (according to diagram below) and program in PBX:

• connect 'EZ' output of TBRD.CR to 'EZ'
• connect 'POD' input of TBRD.CR with 'EZ' output of DPH.IP

PBX configuration:

• IPx/CCT/MAC
  • for DPH.IP doorphone in ConfigMAN Peripherals/Doorphones/DPH.IP/Hardware settings set option:
    • OpMD (Output mode 'EZ' ): Switched off
  • for CR0RF reader in ConfigMAN Peripherals/Doorphones/DPH.IP/Hardware settings set options:
    • POD (POD): Button
    • NmPOD (Normal POD state): Normally open

• NCP
  • for DPH.IP doorphone in Extensions/Devices/DPH.IP/Doorphones/EZ output settings set option:
    • Enabled, Mode: Normally inactive
  • for CR0RF reader in Extensions/Devices/DPH.IP/Doorphones/POD input settings set options:
    • Enabled, Resting state: Normally open
    • If POD button is pressed: Open EZ lock: V