ITS - Outgoing calls
ITS offers 3 methods of realizing outgoing calls:
- Outgoing via 0
- Generic - automatic outgoing,
- Manual selection of specified outgoing line(FXO or IPO)
Outgoing via zero
Starting from firmware version 1.01.1080 global option, which interprets as outgoing all numbers with zero, was added. Settings this option is available in pane Global options: Reaching public newtork by 0. Further steps should be the same as for option: Generic - automatic outgoing.
Generic - automatic outgoing
|Pane Subscribers (FXS) or IP Subscribers (IPS) section Additional options
For every subscriber one of following outgoing option should be set:
For specified subscriber one of following outgoing rules can be assigned: Outgoing rule 1 or Outgoing rule 2,
Fixed assignment of specified outgoing line FXO or IPO
It means, that specified subscriber, independently on dialed number will be routed via assigned in configuration outgoing line.
Selection of outgoing calls scenario. By default: Outgoing rule 1
Outgoing rule - number dialing scenario
|For specified subscribers one of two outgoing scenario can be set: Outgoing rule 1 or Outgoing rule 2
Configuration of scenario: Outgoing rule:
Scenario tables: Outgoing rule 1/2
Options All FXO's/All IPO's
- Seizing lines for option All FXO's: Line 41->Line 42->Line 41 etc....seized cyclically. It can be also used if only one line is connected.
- Seizing lines for option All IPO's: IPLine 51->IPLine 52->IPLine 53->IPLine 54->IPLine 55->IPLine 56->IPLine 51 etc....so next after lastly occupied.